Materials Handling and Storage

The employer shall provide a training program to train all employees who service rim wheels in the hazards involved in servicing those rim wheels and the safety procedures to be followed. (i) The employer shall assure that no employee services any rim wheel unless the employee has been trained and  instructed in correct procedures of servicing the type of wheel being serviced, and in the safe operating procedures described in paragraphs  and of this section. Technical Data used in the field explained in osha courses in Rawalpindi.

Information to be used in the training program shall include at a minimum, the applicable data contained in the charts (rim manuals) and the contents of this standard. Where an employer knows or has reason to believe that any of his employees is unable to read and understand the charts or rim manual, the employer shall assure that the employee is instructed concerning the contents of the charts and rim manual in a manner which the employee is able to understand. Some more details of osha courses in Rawalpindi are as under.

Safe operating procedure — multi-piece rim wheels:

The employer shall establish a safe operating procedure for servicing multi-piece rim wheels and shall assure that employees are instructed in and follow that procedure. The procedure shall include at least the following elements:

 Tires shall be completely deflated before demounting by removal of the valve core. Tires shall be completely deflated by removing the valve core before a rim wheel is removed from the axle in either of the following situations:

 When the tire has been driven underinflated at 80% or less of its recommended pressure, or  When there is obvious or suspected damage to the tire or wheel components.

 Rubber lubricant shall be applied to bead and rim mating surfaces during assembly of the wheel and inflation of the tire, unless the tire or wheel manufacturer recommends against it. If a tire on a vehicle is underinflated but has more than 80% of the recommended pressure, the tire may be inflated while the rim wheel is on the vehicle provided remote control inflation equipment is used, and no employees remain in the trajectory during inflation.

Cracked, broken, bent or otherwise damaged rim components shall not be reworked, welded, brazed, or otherwise heated. Whenever multi-piece rim wheels are being handled, employees shall stay out of the trajectory unless the employer can demonstrate that performance of the servicing makes the employee’s presence in the trajectory necessary. No heat shall be applied to a multi-piece wheel or wheel component. TSK Training for Skills and Knowledge is the best institute in Rawalpindi Islamabad for  Pakistani Students who wants to join osha courses in Rawalpindi.